To celebrate the end of the decade and ten years of CQUARTZ, we are proud to introduce the next evolution. After intense research, development, and testing, CQUARTZ SiC is ready to continue where Tio2 left off! As the name would suggest, this new formula also includes SiC (Silicon Carbide) for additional resistance against chemicals! Not only that but CQUARTZ SiC greatly improves the ease of use, resistance to water (mineral) spots, and even amped up the gloss! Finally, the slickness will leave you thrilled with the finished product!
Buy yours today and experience the new CQUARTZ SiC!
If contamination exists, CARPRO Iron X and clay your vehicle before polishing.
To gain the most from CQUARTZ your vehicle should have all surfaces 100% clean and paint polished to a high level.
Use CARPRO Reflect to achieve an incredible high gloss finish in less time with no fillers.
Use CARPRO Eraser to remove any oils leftover after polishing - This is critical to ensure durability of CQUARTZ.
We recommend coating removal towels: CarPro BOA is ideal
We recommend extra suede applicators if applying more than 1 coat -
Wrap a 4" microfiber suede around the grey side of applicator block.
DO NOT SHAKE. Slowly open bottle and drag one line of product down the applicator.
Spread across paint in a criss cross pattern approximately 2 sq ft at a time depending on conditions.
Buff off about 5 minutes later once it looks less wet but is not yet difficult to wipe. (3~15 minutes depending on temperature and air movement) - see additional tips below) using a CarPro Two Face MF
Be sure to remove all excess residue when wiping off.
Switch out the 4" Suedes every 2+/- panels.
Additional coats may be applied with 45-60 minutes or wait until the following day if you are beyond 90 minutes. CARPRO recommends 2 coats. You may apply additional coats if you wish.
Do NOT top with Reload during initial installation. Reload can damage SIC if used in the first few days. SiC is very slick on its own and in fact more slick then Reload.